MeasureFit Plus

MeasureFit Plus is a powerful fitting package that works as an add-on to Measure X and MeasureMind 3D metrology software. Through handing and analysis of large sets of data, MeasureFit is able to identify potential assembly issues.

The software analyses all measured component features simultaneously and compares them to a nominal design template created from measurement routines. MeasureFit then determines a best-fit match between the template and component measurement results. The software colour codes this data and generates a graphic representation, allowing the operator to establish if the data is consistent or if there are existing trouble spots, trends and potential problems.

MeasureFit Software reads all measured geometries, dimension constructions, tolerances, and Datum reference frames contained in Measure X and MeasureMind routines. Providing the ability to add MMC to datum features, apply the most appropriate fit method and deliver results both graphically and numerically.

OLE compliant MeasureFit Plus software is easily accessible through a tab that appears when integrated with Measure X base software, allowing, MeasureFit to use the same interface. Once integrated there is no switching between separate applications, this tight integration allows fitting operations to be stored and played back as part of the Measure X inspection routine.

MeasureFit can be used in a stand-alone or off-line mode and also import and export DXF files. DXF files can be converted into MeasureFit Plus project files that contain datums, GDT tolerances and material condition of features. Data point files can be imported and used to compare against project files and results can then be stored in an archive containing all numeric and graphic results.


Book a demo